User's Manual

Vst/Pst Controller Ver. A1.00
Installation Requirements
P/N 1100035 page 3-3
3. Installation Requirements
• The intended application of the system is for the commercial and or industrial uses.
• The product can not be sold to the general public, but only to the system’s Operating
Company. When the system is sold by the Operating Company to the customers, the
Product is installed only by the professional installers, qualified (“licensed”) by the
company for this purpose.
• The installation must be controlled and follow the requirement of “Installation Manual”.
Each potential installer receives special training, which is a condition for receiving the
license from the Operating Company to become a “licensed” installer. The installation
itself is a complex procedure, as described in the “Installation Manual”. It includes not
only the mechanical installation, but additional procedure of interconnection to the main
computer via modem, software initialization, registration of the specific Product in the
Operating Company’s control center, performance of the initial test procedure. All these
are the tasks of the Product installer, which can only performed by specially trained
professional.
system requires installation of certain electrical equipment that must be performed by a licensed
electrician.
120VAC supply to the VST/PST Controller must be done in accordance with National
Electric Code (NEC) requirements.
Installation and wiring of VST antenna must be performed by a qualified technician.
The VST antenna requires separate grounding Use 10AWG wire to connect between
the antenna mounting bracket and ground.
.Note: Outdoor units and antennas should be installed ONLY by experienced
installation professionals who are familiar with local building and safety codes
and, wherever applicable, are licensed by the appropriate government
regulatory authorities. Failure to do so my void the OTI product warranty and
my expose the end user or the service provider to legal and financial liabilities.
OTI and its resellers or distributors are not liable for injury, damage or
violation of regulations associated with the installation of outdoor units or
antennas.
WARNING:
It is the responsibility of the installer to ensure that when using the outdoor
antenna kits in the United States (or where FCC rules apply), only those antennas
certified with the product are used. The use of any antenna other than those
certified with the product is expressly forbidden in accordance with FCC rules
CFR47 part 15.204."
The installer should configure the output power level of antennas, according to
country regulations and per antenna type.