User's Manual

SCIBA2 User & Installation Manual Version 1.00
Introduction
page 1-1
1 Introduction
The SCIBA2 reader is an inexpensive, compact radio frequency
communications electronic interface unit. Bi-directional RF communication
to contactless smart cards, serial communication to application controller
and rich set of macro commands make it the keystone in contactless smart
card systems.
The SCIBA2 can be integrated into existing systems. Using USB
interface between reader and Host, the SCIBA2 allows bi-directional,
communication between the Host and passive, contactless smart card.
Optional RS232 or RS485 Host communication link is also available.
The SCIBA2 reader serves as a smart interface unit between the application
controller and:
1. ISO 14443 Type B Contactless smart cards.
2. ISO 14443 Type A Contactless smart cards.
3. Mifare Contactless smart cards
4. Optional ICODE contactless smart cards
5. Up to four Secured Applications Modules (SAM)
At the Host’s command, the SCIBA2 generates and modulates a 13.56 MHz
carrier signal for the transmission of power, commands and data to an in-
range smart card. The SCIBA2 detects the, signal encoded by the card
automatically choosing the modulation technique required by the card. Read
and write operations have equal data rates and range.
By utilizing a matched antenna, the SCIBA2 communication technology is
unique in allowing for a remote antenna configuration (up to 33 meters).
Secured Transactions
Secured Purse to Purse transactions can be achieved between card and “on
board” SAM Secured Applications Module.
Digital IO
The SCIBA2 optionally supports up to 8 Digital Inputs & 16 Digital
Outputs via onboard connectors.
Operating Voltage
The SCIBA2 can operate from 7.0 to 15VDC