User's Manual

SCIBA2 User & Installation Manual Version 1.00
Flash Memory Programming
page 5-11
5 Flash Memory Programming
5.1 Introduction
The SCIBA2 reader’s program is stored in its non-volatile Flash Memory.
Application versions and updates to the SCIBA2 reader’s program may be
written only at OTI.
The application versions and updates can be programmed into the SCIBA2
reader’s Flash memory by the customer through use of the Flash Memory
Programmer software, described in the following paragraphs.
5.2 PC requirements
 Flash Memory Programmer software runs on Windows 95 or
Windows NT 32bit operating systems.
 PC should be at least a 486 DX2.
Program loading time depends on the speed of PC.
5.3 Programmer Software Installation
1. Run the setup.exe file from CD.
2. Follow the instructions on the PC screen.
5.4 Hardware Setup
1. Connect RS232 cable between PC and SCI interface.
Note: DTR and DSR as well as CTS and RTS in the PC connector
should be shorted. For 25-pin D type connector, short between 4 & 5
and between 6 & 20.
For 9-pin D type connector, short between 4 & 6 and between 7 & 8.
2. Apply power to the reader