User's Manual

GBI Antenna Controller User Manual Ver. 1.00
Jumper & Dip Switch Settings
P/N 1100031 page e
scanned sequentially in repetitive cycles
FCC Compliance
Labeling Requirements
CFR 47, FCC part 15, Sections 15, 19, 109.
A device shall bear the following label in a conspicuous location on the device.
OTi GMS
FCC ID: JNX-OTI-GMS-V1
Manufacturer: On Track Innovations Ltd.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
"
""
"
Reorient or relocate the receiving antenna.
"
""
"
Increase the separation between the equipment and receiver.
"
""
"
Connect the equipment into an outlet on a circuit different from that to
which this receiver is connected.
"
""
"
Consult the dealer or an experienced radio/TV technician for help
Changes or modifications in this equipment, not expressly approved by the
party responsible for compliance (On Track Innovations Ltd,) could void the
user’s authority to operate the equipment.