User's Manual

GBI Antenna Controller User Manual Ver. 1.00
Jumper & Dip Switch Settings
P/N 1100031 page d
4. Jumper & Dip Switch Settings
4.1 J10 - J13
Channel enable Jumpers-
should be placed to enable normal microprocessor
controlled operation of the desired channel.
CH1 CH2 CH3 CH4
J10
x
J11
x
J12
x
J13
x
4.2 Communication Jumper J7
Jumper J7 should be placed in RS232 position for RS232 applications or in RS422
position for RS422/RS485 applications.
4.3 Transmission Channel Jumpers
Jumpers SL1, SL2, SL3, & SL 4 for channels 1 to 4 respectively offer the following
modes:
1) MT position - normal microprocessor controlled data transmission.
2) Off position - no transmission.
3) No jumper - constant transmission.
4.4 Normal Operation Jumper Settings
1) Jumpers J10
→
J13 should be placed to enable operation of desired channel
2) Jumpers SL1
→
SL4 should be placed in MT position.
3) Jumper J7 should be placed in RS-232 or RS-422 position depending on
application
4) The following jumpers should be removed for normal operation:
J1, J2 J16 J19&J6.
5) The following jumpers should be installed for normal operation:
TXDATA
4.5 Dip Switch SW1
12345678
ON
OFF
SW1
Sw1 selects the address of the first channel of the MCI for RS-232/422
network operation. Addresses of channels 2, 3 and 4 follow in sequential
order. The address number (0-255) is binary coded, #1 being the most
significant bit and #8 being the least significant bit.
Address #0 is reserved for self-diagnostics. In this mode the channels are