Manualshelf

Data Sheet

ManualsBrandsON SEMICONDUCTOR ManualsOptoelectronics & DisplaysOpto-isolator - gate-drive SMD 8 Op
12345678910
©2005 Fairchild Semiconductor Corporation www.fairchildsemi.com
6N137, HCPL2601, HCPL2611, HCPL2630, HCPL2631 Rev. 1.0.8 2
Single-Channel: 6N137, HCPL2601, HCPL2611 Dual-Channel: HCPL2630, HCPL2631 — High Speed 10MBit/s Logic Gate Optocouplers
Absolute Maximum Ratings
(T
A
= 25°C unless otherwise specified)
Stresses exceeding the absolute maximum ratings may damage the device. The device may not function or be
operable above the recommended operating conditions and stressing the parts to these levels is not recommended.
In addition, extended exposure to stresses above the recommended operating conditions may affect device reliability.
The absolute maximum ratings are stress ratings only.
*For peak soldering reflow, please refer to the Reflow Profile on page 11.
Recommended Operating Conditions
The Recommended Operating Conditions table defines the conditions for actual device operation. Recommended
operating conditions are specified to ensure optimal performance to the datasheet specifications. Fairchild does not
recommend exceeding them or designing to absolute maximum ratings.
*6.3mA is a guard banded value which allows for at least 20% CTR degradation. Initial input current threshold value
is 5.0mA or less.
Symbol Parameter Value Units
T
STG
Storage Temperature -55 to +125 °C
T
OPR
Operating Temperature -40 to +85 °C
T
SOL
Lead Solder Temperature (for wave soldering only)* 260 for 10 sec °C
EMITTER
I
F
DC/Average Forward Single Channel 50 mA
Input Current Dual Channel (Each Channel) 30
V
E
Enable Input Voltage Not to Exceed
V
CC
by more than 500mV
Single Channel 5.5 V
V
R
Reverse Input Voltage Each Channel 5.0 V
P
I
Power Dissipation Single Channel 100 mW
Dual Channel (Each Channel) 45
DETECTOR
V
CC
(1 minute max)
Supply Voltage 7.0 V
I
O
Output Current Single Channel 50 mA
Dual Channel (Each Channel) 50
V
O
Output Voltage Each Channel 7.0 V
P
O
Collector Output Single Channel 85 mW
Power Dissipation Dual Channel (Each Channel) 60
Symbol Parameter Min. Max. Units
I
FL
Input Current, Low Level 0 250 µA
I
FH
Input Current, High Level *6.3 15 mA
V
CC
Supply Voltage, Output 4.5 5.5 V
V
EL
Enable Voltage, Low Level 0 0.8 V
V
EH
Enable Voltage, High Level 2.0 V
CC
V
T
A
Low Level Supply Current -40 +85 °C
NFan Out (TTL load) 8