Cut Sheet

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone [phone]
www.legrand.us/onq
Page 2 of 3
SB006-IM
Integration Module – Outputting Video Door
Station and Camera Signals to Secondary
Video Devices
©Copyright 2011 by Legrand. All Rights Reserved.
The next step to completing this solution is to have the ability to output the video image from the
Selective Call Video Door Stations. A Selective Call 8-Location Distribution Module (IC5001) is
required for each video door station that will output video. The Integration Module supports two video
door stations, requiring two modules to complete the installation.
The next step will require the creation of a custom Cat 5e cable. This custom cable will connect to the
Video Cascade output port on the Integration Module and then connect to each of the Selective Call
modules on the system. To create the custom cable, crimp one end of the Cat 5e cable using the
568A standard. That end will connect into the Video Cascade port. On the other end of the wire, you
will need to split the pairs off into two plugs. On the first plug, take pins one and two (white/green and
green) and place them in the position of pins seven and eight (where the white/brown and brown
would normally go). On the second plug, take pins seven and eight (white/brown and brown) and
place them in the position of pins seven and eight. This will give you two plugs, each with pairs
crimped into pins seven and eight. Each plug carries the video signal for one of the video door
stations (See Figure 1).
Finally, to complete the installation, connect each of the plugs from your custom cable into port 8 of
the two Selective Call modules. Both modules require their own PW1030 power supplies or the use of
our PW1010 Universal Power Distribution Module. You can then output the video signal from the
yellow RCA output right below port eight. You can connect that video output to whatever secondary
video device you choose (See Figure 1).