User Manual

This machine is intended for use engraving signs and other consumer products on applicable substrates. This laser can
process a wide variety of metals including steel, aluminum, titanium, brass, copper, tungsten, carbide, and chrome. It can
also be used with stone and some hard plastics such as acrylic. (See §§2.5 & 4.3 for further details.) Use of this system for
non-designated purposes is not permitted.
The system must be operated, maintained, and repaired by personnel familiar with the field of use and the dangers of the
machine and the material being engraved including its reflectivity, conductivity, potential for creating harmful or
combustible fumes, etc.
Laser beams are dangerous. The manufacturer and/or seller bear(s) no responsibility and assume(s) no liability for any
improper use of this device or for any damage or injury arising from such use. The operator is obliged to use this fiber
laser marker only in accordance with its designated use, the other instructions on the device and in its manuals, and all
applicable local and national laws and regulations.
2
Model LYF-30BWe
Input Power 110V/60Hz
Rated Power 30W
Expected Service Life 100,000 hr.
Laser Wavelength 1064 nm (1.064 µm)
Laser Frequency 30–60 kHz
Processing Area 6.9×6.9 in. (17.5×17.5 cm)
Max. Marking Speed 275.6 ips (700 cm/s)
Min. Marking Depth 0.0002 in. (0.005 mm)
Max. Marking Depth 0.003 in. (0.08 mm) on a single pass
Min. Line Width 0.006 in. (0.15 mm)
Precision ±0.1 µm
Required Operating Environment <70% Humidity and 40–95°F (5–35°C)
Required Operating Software SeaCAD
1.3 Designated Use
1.4 Technical Specifications