User's Manual

V750 RFID READER/WRITER, ANTENNA 2006-06, REV.C
OPERATION MANUAL
77 of 110
©OMRON CORPORATION 2006
(1) SET Communication (SETC)
While the command is being executed, setting conditions in the Reader/ Writer are changed.
This setting is enabled when another communication command is executed. To write the setting data into
the nonvolatile memories in the Reader/Writer, SAVE communication setting command (SAVE) shall be
executed. The new setting shall be enabled at the upcoming startup.
Command SETC (S) param1=value1 (S)... param n=value n<LF>
 It specifies a parameter connecting a setting item to a setting value. (‘The
setting item does not have to be prepended with ‘ -‘ .)
 No space shall be put in from the beginning of the setting item to the end of the
setting value unless setting item is ft1 or ft2.
 If the setting item is ft1 and/or ft2, the five items shall be specified with space
separation between each item. Instead of space, enclosing double quotations is not
allowable.
 In a single command, multiple setting items can be specified by separating with
space. A 2 or more character space is acceptable for indicating separation.
Response SETC0000<LF>
＊(S) Space Character
Example 1) When [Port 1 power; 10, Session; S1］is specified:
[Tx] SETC cp1=10 ss1=1<LF>
[Rx] SETC0000<LF>
Example 2) When [Filter; 1 or 2, Filter1; Bank 1, Address; 20, Dat; 0x**11, Filter2; Bank 1, Data Pointer; 20,
Dat; 0x1211] is specified:
[Tx] SETC ft1=0 1 20 XX11<LF>
[Rx] SETC0000<LF>
[Tx] SETC ft2=0 1 20 1211<LF>
[Rx] SETC0000<LF>
[Tx] SETC fte=1|2 <LF>
[Rx] SETC0000<LF>