User's Manual

V750 RFID READER/WRITER, ANTENNA 2006-06, REV.C
OPERATION MANUAL
75 of 110
©OMRON CORPORATION 2006
3.1.5.4 Setting for Communication Conditions
To setting the conditions to communicate with tags, following items shall be specified in the SET
Communication command (SETC) and GET Communication command (GETC). Specifying following option
allows the Reader/Writer to set or read the communication condition. To write the setting data into the
nonvolatile memories in the Reader/Writer, SAVE communication setting command (SAVE) shall be executed.
Smoothing Function (GETC/SETC)
Code Content User setting value Factory
Settings
Value setting Value selecting
SBF Prevents repeat read
(Smoothing Buffer)
-Min: 0
-Max: 999
-Step: 1
0:Disable
ONR Omit No Tag Response 0:Disable
1:Enable
0:Disable
Filtering Function (GETC/SETC)
Code Content User setting value Factory
Settings
Value setting Value selecting
FTE Filtering Enable 0:None
1:Filter1
2:Filter2
1&2:Filter1 and Filter2
1|2: Filter1 or Filter2
0:None
FT1 Filtering condition 1 Filter type:0
MemBank:0-3
Pointer:0x00…0xFF(bit)
Length:0x00…0xFF(bit)
Value:0x0…(Hex)
(None)
FT2 Filtering condition 2 Same as FT1
(None)
RF Control Conditions (GETC/SETC)
Code Content User setting value Factory
Settings
Value setting Value selecting
SS1 Gen2 Session value
In case of Once Mode
reading
0
1
2
3
0
SS2 Gen2 Session value
In case of Repeat Mode
reading
0
1
2
3
2
PW1 UHF Power Level (Port1) -Min: 10.0
-Max: 32.0
-Step: 0.5
31.5 (dBm)
PW2 UHF Power Level (Port2) Same as PW1 31.5 (dBm)
PW3 UHF Power Level (Port3) Same as PW1 31.5 (dBm)
PW4 UHF Power Level (Port4) Same as PW1 31.5 (dBm)
CMD Communication mode 0:Normal mode
1:Dense reader mode
(DRM)
0:Normal
mode