User's Manual

V750 RFID READER/WRITER, ANTENNA 2006-06, REV.C
OPERATION MANUAL
37 of 110
©OMRON CORPORATION 2006
IP address
192.168.1.100
Subnet mask 255.255.255.0
4. Browse to…
http://192.168.1.200 or
http://
v740 (dhcp name)
The
V750 reader browser-based interface to the reader is displayed.
5. Click the Set Reader link in the navigation menu. The Modify Settings page appears.
6. If you wish to use DHCP, modify the “Use DHCP?” setting by selecting the “Yes” radio button; otherwise,
enter the required network settings in the IP Address, Subnet Mask, and Gateway fields. The fields will turn
red if the gateway is not on the same subnet as the IP address. Then, click the
Save Changes
button.
IMPORTANT:
Do not disconnect power until the save process is completed.
7. Set the reader RF power per instructions on page to correspond to antenna and cable types.
8. Verify that the settings shown are correct. Then, restart the reader by disconnecting the power cable and
then reconnecting it.
It may take about 60 seconds for the reader to restart. If the reader IP address was changed, you must
type the new address into the PC browser address field to communicate with the reader.
IMPORTANT: Do not disconnect and connect power cable at the DC cord. Always disconnect and
connect power cable at the AC cord.
9. Once the system restarts, click
Settings
. You are taken to the
Modify Settings
page. Your changes will
be saved and then applied. After the reader reconfigures its network interfaces, it will automatically redirect
you to its status page. There is no need to restart the reader.
IMPORTANT: Do not disconnect power while the reader is saving its new configuration.
The reader is now ready to receive commands from the network.
10. Use the Query page of the browser-based interface to verify the reader and antenna operation by reading
tags.
11. Close the browser window. Start an application to control the reader on the network.