English Français Deutsch Italiano Español Digital Ear Thermometer Model Gentle Temp® 520 Instruction Manual Nederlands Türkçe IM-MC-520-E-01-03/2013 9042329-5A
Important Safety Information To assure the correct use of the product basic safety measures should always be followed including the precautions listed below. Warning: • Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. • Conducting self-diagnosis based on the measurement results and/or treatment can be dangerous. Please follow the instructions of your doctor. Self-diagnosis may worsen the symptoms.
Important Safety Information • Do not attempt measurements when the unit is wet as inaccurate readings may result. • Check the symbol on the display before and after the measurement so that the measurement is taken in the appropriate mode. • Keep the unit out of children’s reach. • Avoid children trying to measure themselves or others as they may damage the ear. • In an emergency case, if a child swallows a battery or a probe cover, immediately consult with a doctor. • Do not throw batteries into a fire.
1.
2. Preparation 2.1 Removing the Insulating Tape Pull the insulating tape out from the battery compartment by catching hold of the outer part for the first time. 2.2 Switching between °C and °F This unit is set in °C as default. 1. 2. 4 While the power is off, press and hold the START button. While holding it down, press and hold the ON/MEM button until °F appears on the display with 2 beeps. Notes: • To select the °C mode, start from step1.
2. Preparation 2.3 Setting the Buzzer The buzzer is set on as default. 1. Press the ON/MEM button to turn on the unit. 2. Press and hold the ON/MEM button for 3 seconds. The “ 3. EN ” symbol flashes on the display. Release the ON/MEM button. The “ ” symbol remains lit and the buzzer is set to off. Notes: • If the ON/MEM button is pressed down for more than 5 seconds after the “ setting the buzzer. • To turn the buzzer on, start from step1.
2. Preparation 2.4 Attaching a Probe Cover Always use a new and undamaged OMRON MC-EP2 probe cover. 1. Gently twist off the probe cap. Note: Do not forcibly remove the probe cap. 2. Place a new probe cover on the connection ring. Place Adhesive Side Upward Note: The adhesive side of probe cover should be upward. Probe cover Connection ring 3. Insert the probe into the probe cover on the connection ring until it clicks.
3. Using the Unit 3.1 Taking a Reading Notes: • Make sure the probe cover is attached correctly. • It is recommended that you measure 3 times with the same ear. If the 3 measurements are different, select the highest temperature. 1. EN Press the ON/MEM button. All symbols appear on the display. Then the display shown at the right will appear with 2 beeps. 2. Insert the probe into the ear as far as it comfortably goes in the direction of the eardrum.
3. Using the Unit Measuring the temperature of an infant 8 Measuring on a lying baby. Measuring on a sitting baby. The ear is too small to insert the probe. Lightly support the child’s body. Lightly support the child’s body and slightly pull the ear towards the back. While slightly pulling the ear back, cover the external auditory canal with the probe without forcibly trying to insert the probe.
3. Using the Unit 3. Press the START button. EN The measurement is complete in 1 second with a long beep. The “ ” symbol will flash for 5 seconds. Note: You can take another measurement after 2 beeps. Make sure “ ” symbol remains lit. 4. Remove the unit from the ear and check the measurement result. Note: If your measurement result is over 37.5°C(99.5°F), the buzzer will beeps three times after a long beep. After each Ear Measurement, the unit needs 5 seconds to be ready for next measurement.
3. Using the Unit 3.2 Using the Memory Function This unit automatically stores the results up to 9 sets after each measurement. Note: If the memory is full, the unit will delete the oldest reading. 1. Press the ON/MEM button to turn on the unit. 2. Press the ON/MEM button again. The memory number appears on the display. 3. Release the ON/MEM button. The most recent result will appear on the display. Press the ON/MEM button repeatedly to view the older results. 4.
4. Troubleshooting and Maintenance 4.1 The Icons and Error Messages Error Display Cause Remedy EN Device stabilization in process. Wait until Battery is low. Replace the battery. (Refer to section 4.3) Probe cover is not attached correctly. Attach the probe cover again until Measurement before device stabilization. Wait until The device is showing a rapid ambient temperature change.
4. Troubleshooting and Maintenance Error Display 4.2 Cause Remedy Temperature taken is higher than 42.2°C (108.0°F). Check the integrity of the probe cover and take a new temperature measurement. Temperature taken is lower than 34.0°C (93.2°F). Make sure the probe cover is clean and take a new temperature measurement. Device can not be powered on to the ready stage. Change to a new battery. (Refer to section 4.3) Maintenance • Please check the device if damaged after it is dropped.
4. Troubleshooting and Maintenance 4.3 Replacing the Battery Battery: CR2032 Lithium Button Battery Note: To protect the environment, discard the used batteries in accordance with the local regulations regarding waste disposal procedure. Disposal can be done at your retail store or at appropriate collection sites. 1. Insert a pointed object into the battery cover pick hole. Slide and remove the battery cover with your thumb. 2. Remove the battery with a pointed object.
5. Technical Data Product Description: Model: Sensing Unit: Temperature Display: Measurement Accuracy: Measurement Range: Power Supply: Power Consumption: Battery Life: Operating Environment Temp and Humidity: Storage Environment Temp and Humidity: Protection against electric shock: Applied Part: Digital Ear Thermometer Gentle Temp 520 (MC-520-E) Thermopile 4-digit, °F display in 0.1 degree increments 3-digit, °C display in 0.1 degree increments ± 0.2°C (± 0.4°F) within 35.5°C to 42.0°C (95.9°F to 107.
5. Technical Data Outer Dimensions: Package Content: Options: 36 mm (w) × 161 mm (h) × 56 mm (d) Test Battery (Lithium Button Battery CR2032), probe cap, 21 probe covers, connection ring, instruction manual. Probe cover exclusively for Gentle Temp 520, MC-EP2. EN Notes: • The specification may be changed without prior notice. • This OMRON product is produced under the strict quality system of OMRON HEALTHCARE Co. Ltd., Japan.
5. Technical Data OMRON Digital Ear Thermometer Model: Gentle Temp 520 (MC-520-E) Information for accompanying documents in the scope of IEC60601-1-2:2007 Important information regarding Electro Magnetic Compatibility (EMC) With the increased number of electronic devices such as PC’s and mobile (cellular) telephones, medical devices in use may be susceptible to electromagnetic interference from other devices.
6. Some Useful Information 6.1 Temperature measurements taken within the ear The Gentle Temp 520 Digital Ear Thermometer detects the infrared heat given off by the eardrum and surrounding tissues, and it converts this heat into an equivalent ear temperature. The Gentle Temp 520 is less threatening to a child than a rectal thermometer. It’s faster, safer and easier to use than an oral thermometer. Being digital, there’s no worry about the hazard of broken glass or mercury ingestion.
6. Some Useful Information As ambient temperature, sweat, or saliva easily affects body temperature measured under the arm or the tongue, readings may be lower than the core temperature. Tympanic temperature measurement accurately reflects the brain temperature and can lead to a quicker detection of fever.
6. Some Useful Information 6.3 Ear temperature compared to other types of body temperature The normal temperature varies according to different locations on the body. 6.4 EN Questions and answers How many times can I measure consecutively? You can measure consecutively up to three times. The main unit will then be warmed up and may not be able to measure correctly. If you are going to measure more than three times, wait for 10 minutes, then measure again. The temperature indicated is rather high.
6. Some Useful Information Is the temperature measured in the right ear different from that measured in the left ear? Among healthy people, there should be no significant difference in the measurement results. Differences may be caused by the following reasons: 1) The infrared sensor is not inserted in the same way. 2) Measurement is not conducted by inserting the unit in a stable manner in the same angle. Try to measure in the ear that consistently shows a higher measurement.
Manufacturer OMRON HEALTHCARE Co., Ltd. 53, Kunotsubo, Terado-cho, Muko, Kyoto, 617-0002 JAPAN EU-representative OMRON HEALTHCARE EUROPE B.V. Scorpius 33, 2132 LR Hoofddorp, THE NETHERLANDS www.omron-healthcare.com Subsidiary Succursale Niederlassung Consociata Empresa filial Dochteronderneming OMRON HEALTHCARE UK LTD. Opal Drive, Fox Milne, Milton Keynes, MK15 0DG, U.K. OMRON MEDIZINTECHNIK HANDELSGESELLSCHAFT mbH Gottlieb-Daimler-Strasse 10, 68165 Mannheim, GERMANY www.