Datasheet
7
SS Subminiature Basic Switch
S
S 
Precautions 
★Please refer to "Common Precautions" for correct use. 
●Soldering
• Complete the soldering at the iron tip temperature below 
350°C within 5 seconds, and do not apply any external force 
for 1 minute after soldering. Soldering at an excessively high 
temperature or soldering for more than 5 seconds may 
deteriorate the characteristics of the Switch. 
• Be sure to apply only the minimum required amount of flux. 
Switch may have contact failures if flux intrudes into the 
interior of the Switch. 
• If the PCB terminal models are soldered in the solder bath, flux 
will permeate inside the Switch and cause contact failure. 
Therefore, manually solder the PCB terminal. 
●Mounting 
• Use M2.3 mounting screw with plane washers or spring 
washers to securely mount the Switch. Tighten the screws to a 
torque of 0.23 to 0.26 N·m {2.3 to 2.7 kgf·cm}.
• Mount the Switch onto a flat surface. Mounting on an uneven 
surface may cause deformation of the Switch, resulting in 
faulty operation or breakage in the housing. 
●Using Micro Loads 
Using a model for ordinary loads to open or close the contact of 
a micro load circuit may result in faulty contact. Use models that 
operate in the following range. However, even when using micro 
load models within the following operating range, if inrush 
current occurs when the contact is opened or closed, it may 
increase the contact wear and so decrease durability. Therefore, 
insert a contact protection circuit where necessary. The N-level 
reference value applies for the minimum applicable load. This 
value indicates the malfunction reference level for the reliability 
level of 60% (λ
60). 
(JIS C5003) 
The equation, λ
60=0.5×10
-6
/operation indicates that the 
estimated malfunction rate is less than operations with 
a reliability level of 60%. 
Cautions  Correct Use 
1
2,000,000
30
24
12
5
0
1 10 100 1,000
Current (mA)
0.1
1 mA
Operating
range for
general-load
models
SS-5
SS-10
Operating range for 
micro-load model
SS-01
26 mA0.16mA
100 mA 160mA
100 mA
Voltage (V)








