User manual

8
Additional battery
signal connection
Additional battery
connection
Additional battery
signal connection
Additional battery
connection
ON
OFF
Overcurrent protection
switch
Battery connection
cable
2-2-3 BUM300S connection procedure / Connectable UPS : BU3002SW
(1) Connect the battery connection cable to the battery connectors on the rear side of the unit and UPS.
Connect the signal connection cable to the additional battery signal connector also.
(2) Turn ON the overcurrent protection switch on the back of the battery unit. Connect the AC input plug of the
unit to a wall outlet. The additional battery lamp on the unit's operation panel turns ON.
UPS BUM300S
2-2-2 BUM150S connection procedure / Connectable UPS : BU150SW
(1) Connect the end of the battery cable connected to the back of the BUM150S to the UPS additional battery
connector and additional battery signal connector.
When a 1050W device is connected, the backup time
is 20 minutes (initial battery value at an ambient tem-
perature of 20°C).
When the battery is completely discharged, it takes
24 hours to charge.
(2) Turn ON the overcurrent protection switch on the back of
the additional battery unit.
RS232C
信号カード
増設
冷却ファン
OUTPUT AC100-120V 50/60Hz 1ø
出力電力 最大1.5kVA / 1500W
接地
INPUT
AC100V-120V入力
50/60Hz 16A
AC入力
過電流保護
20A
バッテリ増設コネクタ
DC36V/40A
バッテリ増設信号コネクタ
Battery connection cable
Additional battery
connector
Additional battery si
g
nal connector
ON OFF
Overcurrent
protection switch
UPS
BUM150S
When a 2100W device is connected, the backup time
is 24 minutes (initial battery value at an ambient
temperature of 20°C).
When the battery is completely discharged, it takes 24
hours to charge.