HEM-7200-E_B_M01_100917.pdf Check following components! Manufacturer OMRON HEALTHCARE Co., Ltd. 24, Yamanouchi Yamanoshita-cho, Ukyo-ku, Kyoto 615-0084 JAPAN EU-representative OMRON HEALTHCARE EUROPE B.V. Kruisweg 577, 2132 NA Hoofddorp THE NETHERLANDS www.omron-healthcare.
Contents 1 2 Thank you for purchasing the OMRON M3 Digital Automatic Blood Pressure Monitor. The OMRON M3 is a compact, fully automatic blood pressure monitor, operating on the oscillometric principle. It measures your blood pressure and pulse rate simply and quickly. For comfortable controlled inflation without the need of pressure pre-setting or re-inflation the devices uses its advanced “IntelliSense” technology.
HEM-7200-E_A_M_main.book Page 1 Wednesday, September 29, 2010 10:27 AM Important Safety Information Consult your doctor prior to using in pregnancy or if diagnosed with arrhythmia or arteriosclerosis. Please read this section carefully before using the unit. Warning: • Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. (General Usage) • Always consult your doctor. Self-diagnosis of measurement results and self-treatment are dangerous.
HEM-7200-E_A_M_main.book Page 2 Wednesday, September 29, 2010 10:27 AM Important Safety Information (AC Adapter Usage) • Use only the original AC adapter (optional) designed for this unit. Use of unsupported adapters may damage and/or may be hazardous to the unit. • Plug the AC adapter into the appropriate voltage outlet. Do not use a multiple-tap. • Do not use the AC adapter if the unit or the power cord is damaged. Turn off the power and unplug the power cord immediately.
HEM-7200-E_A_M_main.book Page 3 Wednesday, September 29, 2010 10:27 AM 1. Overview Open the rear cover page to read following: The alphabet in the rear cover page correspond to those in the body page.
HEM-7200-E_A_M_main.book Page 4 Wednesday, September 29, 2010 10:27 AM 2. Preparation 2.1 Installing/Replacing the Batteries 1. Remove the battery cover. 2. Insert four “AA” batteries as indicated in the battery compartment and then replace the battery cover. Notes: • If the battery low symbol ( ) appears on the display, turn the unit off then replace all batteries at the same time. • The measurement values continue to be stored in memory even after the batteries are replaced.
HEM-7200-E_A_M_main.book Page 5 Wednesday, September 29, 2010 10:27 AM 2. Preparation 2.2 Setting the Buzzer/ Date and Time 1. Press the button. 2. Set the Buzzer. 1) 2) Push or buttons to select On or Off. Push the EN button to confirm. Off On 3. Set the monitor to the correct date and time before taking a measurement for the first time. 1) Push or change. 2) Push the buttons to button to confirm. Next setting appears. Year Month Day Hour Minute 4.
HEM-7200-E_A_M_main.book Page 6 Wednesday, September 29, 2010 10:27 AM 3. Using the Unit Open both the front and rear covers to read following: The alphabet and number in the cover page correspond to those in the body page. 3.1 Applying the Arm Cuff Remove tight-fitting clothing or tight rolled up sleeve from your upper arm. Do not place the cuff over thick clothes. 1. Insert L the air plug into F the air jack. 2. Put your arm through the cuff loop. 3. Position the arm correctly.
HEM-7200-E_A_M_main.book Page 7 Wednesday, September 29, 2010 10:27 AM 3. Using the Unit 3.2 How to Sit Correctly To take a measurement, you need to be relaxed and comfortably seated, under comfortable room temperature. No eating, smoking or exercising 30 minutes before taking a measurement. • Sit on a chair with your feet flat on the floor. • Sit upright with your back straight. --- c • The cuff should be at the same level as your heart.
HEM-7200-E_A_M_main.book Page 8 Wednesday, September 29, 2010 10:27 AM 3. Using the Unit 3.3 Taking a Reading Notes: • To cancel a measurement, press the O/I START button to turn off the unit and to release the air in the arm cuff. • Remain still while taking a measurement. 1. Press the O/I START button. The cuff will start to inflate automatically. The buzzer will sound when measurement is completed.
HEM-7200-E_A_M_main.book Page 9 Wednesday, September 29, 2010 10:27 AM 3. Using the Unit 2. Remove the arm cuff. 3. Press the O/I START button to turn off the monitor. The monitor automatically stores the measurement in its memory. It will automatically turn off after five minutes. Important: • Recent research suggests that the following values can be used as a guide to high blood pressure for measurements taken at home.
HEM-7200-E_A_M_main.book Page 10 Wednesday, September 29, 2010 10:27 AM 3. Using the Unit 3.4 Using the Memory Function The monitor automatically stores the result up to 60 sets. It can also calculate an average reading based on the measurements from the last three readings taken within 10 minutes. If there are only two readings in memory for that period, the average will be based on two readings. If there is one reading in memory for that period, the average will be based on one reading.
HEM-7200-E_A_M_main.book Page 11 Wednesday, September 29, 2010 10:27 AM 3. Using the Unit To delete all the values stored in memory When the memory symbol ( ) appears, first press the Memory button. Then while holding it down, press the O/I START button simultaneously for about 2-3 seconds. EN Note: You cannot partially delete the stored readings.
HEM-7200-E_A_M_main.book Page 12 Wednesday, September 29, 2010 10:27 AM 4. Troubleshooting and Maintenance 4.1 The Icons and Error Messages Error Display 12 Cause Remedy Irregular or weak pulses are detected. Remove the arm cuff. Wait 2-3 minutes and then take another measurement. Repeat the steps in section 3.3. If this error continues to appear, contact your doctor. Movement during measurement. Carefully read and repeat the steps in section 3.3. Cuff is not applied correctly.
HEM-7200-E_A_M_main.book Page 13 Wednesday, September 29, 2010 10:27 AM 4. Troubleshooting and Maintenance Error Display Cause Remedy Cuff is under inflated. Carefully read and repeat the steps listed under section 3.3. Movement during measurement. Repeat measurement. Remain still and do not talk during measurement. Refer to section 3.3. Air plug disconnected. Insert the air plug securely. Refer to section 3.1. Arm cuff not applied correctly. Apply the arm cuff correctly. Refer to section 3.1.
HEM-7200-E_A_M_main.book Page 14 Wednesday, September 29, 2010 10:27 AM 4. Troubleshooting and Maintenance 4.2 Troubleshooting Problem Cause Arm cuff not applied correctly. Apply the arm cuff correctly. Refer to section 3.1. Movement or talking during measurement. Remain still and do not talk during measurement. Refer to section 3.3. Clothing is interfering with the arm cuff. Remove any clothing interfering with the arm cuff. Refer to section 3.2.
HEM-7200-E_A_M_main.book Page 15 Wednesday, September 29, 2010 10:27 AM 4. Troubleshooting and Maintenance Problem Nothing happens when you press the buttons. Other problems. Cause Remedy The batteries are empty. Replace the batteries with new ones. Refer to section 2.1. The batteries have been inserted incorrectly. Insert the batteries with the correct (+/-) polarity. Refer to section 2.1. • Press the O/I START button and repeat measurement.
HEM-7200-E_A_M_main.book Page 16 Wednesday, September 29, 2010 10:27 AM 4. Troubleshooting and Maintenance 4.3 Maintenance To protect your unit from damage, please observe the following: • • • • • • • • • Do not subject the main unit and the cuff to extreme temperatures, humidity, moisture or direct sunlight. Do not fold the cuff or tubing tightly. Do not inflate the arm cuff over 299 mmHg. Do not disassemble the unit.
HEM-7200-E_A_M_main.book Page 17 Wednesday, September 29, 2010 10:27 AM 4. Troubleshooting and Maintenance 4.4 Storage Keep the unit in its storage case when not in use. 1. Unplug the air tube from the air connector. 2. Gently fold the air tube into the arm cuff. Note: EN Do not bend the air tube excessively. 3. Place the arm cuff and main unit in the storage case. Do not store the unit in the following situations: • If the unit is wet.
HEM-7200-E_A_M_main.book Page 18 Wednesday, September 29, 2010 10:27 AM 5. Optional Parts Medium Arm Cuff Large Arm Cuff Arm circumference 22 - 32 cm Arm circumference 32 - 42 cm CM2-9513256-6 (Model: HEM-CR24) CM1-9997578-9 CL2-9513255-8 (Model: HEM-CL24) CL1-9996760-3 AC Adapter S Adapter S-9515336-9 Using the Optional AC Adapter 1. Insert the AC adapter plug into the AC adapter jack on the rear side of the main unit. 2. Plug the AC adapter into an electrical outlet.
HEM-7200-E_A_M_main.book Page 19 Wednesday, September 29, 2010 10:27 AM 6. Technical Data Product Description Model Display Measurement Method Measurement Range Accuracy Inflation Deflation Memory Rating Power Source Battery Life Applied Part Digital Automatic Blood Pressure Monitor OMRON M3 (HEM-7200-E/ HEM-7200-E8) LCD Digital Display Oscillometric method Pressure: 0 mmHg to 299 mmHg Pulse: 40 to 180/min.
HEM-7200-E_A_M_main.book Page 20 Wednesday, September 29, 2010 10:27 AM 6. Technical Data • This device fulfils the provisions of EC directive 93/42/EEC (Medical Device Directive). • This blood pressure monitor is designed according to the European Standard EN1060, Noninvasive sphygmomanometers Part 1: General Requirements and Part 3: Supplementary requirements for electromechanical blood pressure measuring systems. • This OMRON product is produced under the strict quality system of OMRON HEALTHCARE Co.
HEM-7200-E_A_M_main.book Page 21 Wednesday, September 29, 2010 10:27 AM 6. Technical Data Important information regarding Electro Magnetic Compatibility (EMC) With the increased number of electronic devices such as PC’s and mobile (cellular) telephones, medical devices in use may be susceptible to electromagnetic interference from other devices. Electromagnetic interference may result in incorrect operation of the medical device and create a potentially unsafe situation.
HEM-7200-E_A_M_main.book Page 22 Wednesday, September 29, 2010 10:27 AM 7. Some Useful Information about Blood Pressure What is Blood Pressure? Blood pressure is a measure of the force of blood flowing against the walls of the arteries. Arterial blood pressure is constantly changing during the course of the heart’s cycle. The highest pressure in the cycle is called the Systolic Blood Pressure; the lowest is the Diastolic Blood Pressure.
HEM-7200-E_A_M_main.book Page 23 Wednesday, September 29, 2010 10:27 AM 7. Some Useful Information about Blood Pressure Why is it a Good Thing to measure Blood Pressure at Home? Upper curve: systolic blood pressure Lower curve: diastolic blood pressure mmHg Many factors such as physical activity, 200 anxiety, or the time of day, can influence your blood pressure. A single 150 measurement may not be sufficient for an accurate diagnosis.
HEM-7200-E_A_M_main.book Page 24 Wednesday, September 29, 2010 10:27 AM 7. Some Useful Information about Blood Pressure Classification of Blood Pressure by the World Health Organization The World Health Organization (WHO) and the International Society of Hypertension (ISH) developed the Blood Pressure Classification shown in this figure. This classification is based on the blood pressure values measured on people in a sitting position in outpatient departments of hospitals.
