Controller Link Units Operation Manual

38
Data Links Procedures Section 2-1
1 to 1 Type
Note For automatic data link creation with 1:N allocation, use CX-Net in
CX-Programmer version 3.2 or higher.
Contents Method Nodes Page
a. Set the data link mode
to automatic.
Use Support Soft-
ware for the PLC
including Program-
ming Console (see
note).
Data link startup node
only
The node that is used
to start the data link is
called the startup
node. It is necessary
to decide beforehand
which node will be
the startup node.
113
b. 1:N creation Data link startup node
only
138
c. Set the area
d. Set the data link start
word
e. Set the number of
common send words
per master node
f. Se the number of indi-
vidual send words per
master node
g. Set the number of
send words per slave
node
h. Set the first data link
status word
i. Set the nodes to par-
ticipate in the data
links.