User Manual

28
Section 2 Antennas with Built-in Amplifier
RFID System
User's Manual
Section 2
Specifications and Performance
 Setting Switch
Set SW1-1 on the V680-H01-V2 Antenna and the Controller as shown in the following table.
Differences between the V680-H01 and the V680-H01-V2
As shown in the following table, the V680-H01-V2 supports additional maintenance functions.
Turn ON SW1-1(Antenna) when using the V680-CA1D/CA2D.
Setting Function Default setting
SW1-1 Controller selection
OFF:V680-CA5D01-V@, CS1W-V680C11, or CJ1W-V680C11
ON: V680-CA1D/-CA2D
OFF
SW1-2 Reserved by System (Always set this Switch to OFF.) ---
SW1-3 Reserved by System (Always set this Switch to OFF.) ---
SW1-4 Reserved by System (Always set this Switch to OFF.) ---
Antenna setting Controller setting
V680-H01-V2 V680-CA5D01-V@ CS1W-V680C11
CJ1W-V680C11
V680-CA1D
V680-CA2D
SW1-1: OFF SW4-8: OFF DM20000 + 100 × m+3=0000
SW1-1: ON SW4-8: ON
See Note.
DM20000 + 100 × m+3=0001
See Note. See Note.
: Cannot be used.
: Can be used.(Controller setting not required.)
Note: The high-speed mode cannot be used by the controller's setting.
display functions
V680-H01-V2 V680-H01
SW1-1: OFF SW1-1: ON no switch
Communication Test Mode OK OK OK
Noise Level Measurement
Mode
OK NO NO
Distance Level Measurement
Mode
OK NO NO
Speed Level Measurement
Mode
OK NO NO
Communications Success
Rate Measurement Mode
OK NO NO
Setting switch protection cover
Note: Please attach a setting switch protection cover after setting switch.