User Manual

60
Section 4 Installing Antennas
RFID System
User's Manual
Section 4
Installation
 Connecting and Disconnecting Extension Cables
 Mounting the Antenna
 Removing the Antenna
When loosening the connection ring, always hold the flat surfaces on the Antenna connector with a wrench. If the con-
nection ring is loosened without holding the Antenna connector, the extension cable may be damaged or wire inside the
extension cable may break.
The connector cannot be pulled out without first loosening the connection ring. Completely loosen the connection ring
before pulling out the connector. Pulling on the cable without sufficiently loosening the connection ring may cause the
cable to be damaged or wire inside the cable may break.
1. Align the key on the extension cable con-
nector with the key slot on the Antenna
connector and push the connector all the
way in.
2. Hold the flat surfaces on the Antenna connector
with a wrench, and turn the connection ring clock-
wise to secure the connector
3. Hold the flat surfaces on the Antenna con-
nector with a wrench, and turn the connec-
tion ring counterclockwise to loosen the
connector.
4. Make sure that the connection ring is sufficiently
loose, and then pull the connector straight out.
Antenna connector
Extension cable connector
Key
Key ditch
Connection rin
Flat surface
Connection ring
Flat surface
Antenna connector
Extension cable connector