User's Manual

6
Introduction
RFID System
User's Manual
Introduction
Be sure to observe the following precautions to ensure safe use of the Products.
1. Do not use the product in environments subject to inflammable, explosive, or corrosive gas.
2. Do not disassemble, repair, or modify the product in any way.
3. Because a cable has a locking mechanism, make sure that it has been locked before using the cable.
4. Confirm that the DC power supply is within the rated powersupply voltage (24 VDC +10%/-15%) before
using it.
5. Do not reverse polarity when connecting the power supply.
6. Do not allow water to enter or insert wire in the gaps of the case. Fire or electric shock may result.
7. Provide enough space around the controller for ventilation.
8. Avoid setting up the unit near a highly heat-generating device (such as heater, transformer and large-
capacity resistor).
9. Always turn OFF the power supply to the product before attaching or removing the Antenna.
10. If you suspect that anything is wrong with the product at any time, stop using it immediately, turn OFF
the power supply, and consult with your OMRON representative.
11 When disposing of the product, dispose of it as industrial waste.
12. Do not use thinners, benzenes, acetones and kerosenes for cleaning.
13. Communications performance may be reduced due to mutual interference if more than one Read/Write
Antenna is installed in the same vicinity. Refer to the Operating Manual (Cat.No.SCHI-707) and confirm
that there is no mutual interference between Read/Write Antennas.
14. Multiply the tool by the installation hook, and detach it slowly when you remove the main body.
15. Stop miswiring and the load short-circuit.There is fear of exploding and damaging.
16. Do not assume it in the oil environment.
Precautions for Safe Use