User's Manual

41
RFID System
User's Manual
Section 4 ID Sensor
Section 4
Installation
 Installation Method
1. First hook the ID Sensor Unit to part A, then press it in direction B to mount it to the DIN Track.
2. To disconnect the ID Sensor Unit from the DIN Track, pull the mounting hook downwards, and then
lift the Unit upwards.
Attaching the End Plates
To mount an End Plate easily, first hook the bottom of the End Plate and then
hook the top on the DIN Track, pull the End Plate downwards and tighten the
screw.
Recommended tightening torque: 1.2 Nm.
 Mounting lnterval
The V680-HAM91/-HAM81 ID Sensor Units will generate heat if they are mounted side-by-side. Leave
space between Units of at least 10 mm.
Use at least 2 OMRON DIN Track Spacers. (Each Spacer is 5 mm wide.)
DIN Track
End Plate
End Plate
Mounting Hook
Mounting Hook
DIN Track
PFP-100N2
End Plate
PFP-M
OMRON PFP-100N2
(track length: 1 m)
is recommended.
B
A
10 mm min.
10 mm min.
End Plate
Spacer
Spacer
End Plate
Spacer
PFP-S