User's Manual

Section 4 ID Sensor

RFID System

User's Manual

Section 4

Installation

ID Sensor

Installation

To ensure full functionality of the V680-HAM91/-HAM81 ID Sensor, follow the instructions provided in

this section for installation.

 Installation Site

Do not install the ID Controller in the following locations.

x Locations exposed to ambient temperatures that are not between -10 and 55qC or where there are

radical temperature changes resulting in condensation

x Locations exposed to humidity that is not between 25% and 85%

x Locations subject to corrosive gas, flammable gas, dust, salt, or metal powder

x Locations that will expose the ID Controller to direct vibration or shock

x Locations exposed to direct sunlight

x Locations exposed to spray of water, oil, or chemicals

x Locations more than 2,000 m above sea level

 Mounting in a Panel

The ID Sensor Unit can be used at an ambient temperature range of -10 to 55qC. Be sure to observe

the following precautions.

x Make sure that the Unit is provided with sufficient ventilation space.

x Do not install the Unit close to heaters, transformers, or large-capacity resistors that radiate exces-

sive heat.