User's Manual

RFID System

User's Manual

Section 2 㪥㪫㪣㪧㩷㪠㪛䉶䊮䉰

Section 2

㪥㪸㫄㪼㫊㩷㪸㫅㪻㩷㪝㫌㫅㪺㫋㫀㫆㫅㫊㩷㫆㪽㩷㪚㫆㫄㫇㫆㫅㪼㫅㫋㫊

•Read Mode Setting

Set the operation mode for reading data.

Mode setting switch setting are read only when the power supply is turned ON. Therefore, settings cannot be changed

while the power is being supplied. Turn the power supply OFF before changing the settings.

The position of the arrow in the figure is the

direction in which the setting is made.

㪥㫆㪅㪥㪸㫄㪼㪛㪼㫊㪺㫉㫀㫇㫋㫀㫆㫅

0 DATA READ1 Outputs read data.

1 DATA READ2 Outputs read data as the wire-saving mode.

For details, refer to Mode 2 in Section 5 I/O Interface Control.

p.74

2 VERIFY Compares external input with read data and output match/mismatch.

For details, refer to Mode 2 in Section 5 I/O Interface Control.

p.63

3 - Setting prohibited

(An access mode setting error will occur.)