User's Manual

37
RFID System
User's Manual
Section 4 DeviceNet Remote ID Controller
Section 4
Installation, Connections, and Wiring
Attaching the End Plates
To mount an End Plate easily, first hook the bottom of the End Plate and then hook
the top on the DIN Track, pull the End Plate downwards and tighten the screw.
Recommended tightening torque: 1.2 N·m.
 Mounting Interval
The V680-HAM42-DRT DeviceNet Remote ID Controllers will generate heat if they are mounted side-
by-side. Leave space between the Controllers of at least 10 mm.
Use at least 2 OMRON DIN Track Spacers. (Each Spacer is 5 mm wide.)
10 mm min.
10 mm min.
Spacer
Spacer
End Plate
End Plate
Spacer
PFP-S