User's Manual

36
Section 4 DeviceNet Remote ID Controller
RFID System
User's Manual
Section 4
Installation, Connections, and Wiring
DeviceNet Remote ID Controller
Installation
To ensure full functionality of the V680-HAM42-DRT DeviceNet Remote ID Controller, follow the
instructions provided in this section for installation.
 Installation Site
Do not install the DeviceNet Remote ID Controller in the following locations.
• Locations exposed to ambient temperatures that are not between −10 and 55°C or where there are
radical temperature changes resulting in condensation
• Locations exposed to humidity that is not between 25% and 85%
• Locations subject to corrosive gas, flammable gas, dust, salt, or metal powder
• Locations that will expose the DeviceNet Remote ID Controller to direct vibration or shock
• Locations exposed to direct sunlight
• Locations exposed to spray of water, oil, or chemicals
• Locations more than 2,000 m above sea level
 Mounting in a Panel
The DeviceNet Remote ID Controller can be used at an ambient temperature range of −10 to 55°C. Be
sure to observe the following precautions.
• Make sure that the Unit is provided with sufficient ventilation space.
• Do not install the Unit close to heaters, transformers, or large-capacity resistors that radiate
excessive heat.
 Installation Method
 Mounting to DIN Track
1. First hook the DeviceNet Remote ID Controller to part A, then press it in direction B to mount it to the
DIN Track.
2. To disconnect the DeviceNet Remote ID Controller from the DIN Track, pull the mounting hook
downwards, and then lift the Controller upwards.
DIN Track
End Plate
Mounting Hook
End Plate
65
OMRON PFP-100N2
(track length: 1 m)
is recommended.
DIN Track (recommended)
PFP-100N2
End Plate
PFP-M
A
B