User's Manual

21
RFID System
User's Manual
Section 2 ID Controller
Section 2
Names and Functions of Components
 DeviceNet Connector
The DeviceNet connector port connects the DeviceNet Remote ID Controller to the Master Unit. Use
the enclosed connector.
Enclosed connector model: FKC2.5/5-ST-5.08-RFAUM (Phoenix Contact)
 Power Supply and Ground Connector
The power supply terminals supply 24-VDC power using the enclosed connector.
Enclosed connector model: FKC2.5/3-ST-5.08-RF (Phoenix Contact)
 Antenna Connector
Connect this connector to the V680-series Antenna (V680-H@@).
Refer to System Configuration in Section 1 Product Overview for information on the Antennas that can be connected.
p.14
Pin No. Name Signal type
1 V- Power supply negative
side
2 CAN_L Low communications data
3 Drain Shield
4 CAN_H High communications
data
5 V+ Power supply positive side
Pin No. Name Function
1 +V 24-VDC input terminals
2-V
3 GR Ground terminal
Pin No. Name Signal type
1 S Signal line
2 GND Analog ground
5
4
3
2
1
3
2
1
2
1