User's Manual
33
All the information included in ' ' is ASCII codes except the mark *.
The mark * represents (00) h.
Response in abnormal state
‘XX’
Ter mi na-
tor
Header
Exit Code
@
ADR
Status
CR
The exit code is represented by 2 digits (1 byte) in ASCII as defined in 4-7.
Judgment notify command
Based on the result of the read data, the host can notify the RF interface of the result of judgment in
checking, etc.
@
ADR
Status
CR
Header
Ter mi na -
tor
The Status of (44) h sends OK.
The Status of (48) h sends NG.
4. Write
This command is used to write data on the tag for each page. Data can be written on a desired page. Since
this command also performs the verify read operation, there is no need to execute the verify read operation
again.
Command
Sends the data to be written and pages to be written on as parameters. The number of data to be written
must be equal to "(Number of specified pages) × 4". The data to be written are specified in ascending
sequence starting from the smallest number of the specified page.
Data
1
····
Page Specification Write Data
‘32’
Ter mi na-
tor
CR
Data
n
Commu-
nication
Mode
Bank
Specification
Header
Commnad
A/H
@
ADR
Status
····
····
ADR represents the address number expressed by '30-39' and '41-46' in ASCII converted from the
hexadecimal 0-F. Send (00) h for the Status in 1:1 communication in general.
Response
Returns the exit code ("00" in normal state)
CR
@
ADR
Status
‘00’
Header
Exit Code
Termina-
tor
ADR represents the address number expressed by '30-39' and '41-46' in ASCII converted from the
hexadecimal 0-F. Send (00) h for the Status in 1:1 communication in general.