User Manual
Table Of Contents
- V670 Series
- Introduction
- Contents
- Structure of This Manual
- Chapter 1 Features and System Configuration
- Chapter 2 Specifications and Performance
- Chapter 3 Setting and Installation
- Chapter 4 Functions
- Chapter 5 Control From Host Device
- Chapter 6 How to Use Self-Execution Mode
- Chapter 7 How to Use Programming Console
- Chapter 8 From Startup to Run
- Chapter 9 Characteristic Data Depending on Operating Condition (Reference)
- Appendix
7-5 Functions
7-16
7-5-7 Test
When you check the position of antenna and tag in an applicable communication mode, you can execute the communication in a test
operation to judge whether the location and relative speed are suitable or not.
7-5-7-1 Setting Communication Mode
When you execute the Test Reading and Test Writing, you need to specify a communication mode first.
7-5-7-2 Test Reading
7-5-7-3 Test Writing
Specify a communication mode. Using the
/ key(s) or the
to
keys,
change a communication mode to be displayed.
Decide with the
keys.
Specify the Single Trigger mode as a communi-
cation mode.
Specify the start address and end address.
When you press the
keys, the number of
repeats and a data of tag are displayed.
Specify Repeat Auto as a communication
mode.
Specify the start address, end address and data
to be written.
When you press the
key, the number of
repeats and the result are displayed.