User Manual
Table Of Contents
- V670 Series
- Introduction
- Contents
- Structure of This Manual
- Chapter 1 Features and System Configuration
- Chapter 2 Specifications and Performance
- Chapter 3 Setting and Installation
- Chapter 4 Functions
- Chapter 5 Control From Host Device
- Chapter 6 How to Use Self-Execution Mode
- Chapter 7 How to Use Programming Console
- Chapter 8 From Startup to Run
- Chapter 9 Characteristic Data Depending on Operating Condition (Reference)
- Appendix
5-9
Communication commands to communicate with a tag are described here in this section. The commands are described assuming that
1:1 protocol is used. If 1:N protocol is used, follow the 1:N protocol format. (For details of protocol format, refer to "5-2 Command
Response Format".)
1:1 Protocol
Example of sent data
Example of received data
Command code Data Terminator
TerminatorCommand code Data
Termination code
Retransmis-
sion flag
Status
flag
1:N Protocol
Command codeNode No. Data Terminator
Command codeNode No. Data Terminator
Termination code
Retransmis-
sion flag
Status
flag
Example of sent data
Example of received data
5-6 Communication Command