User Manual
Table Of Contents
- V670 Series
- Introduction
- Contents
- Structure of This Manual
- Chapter 1 Features and System Configuration
- Chapter 2 Specifications and Performance
- Chapter 3 Setting and Installation
- Chapter 4 Functions
- Chapter 5 Control From Host Device
- Chapter 6 How to Use Self-Execution Mode
- Chapter 7 How to Use Programming Console
- Chapter 8 From Startup to Run
- Chapter 9 Characteristic Data Depending on Operating Condition (Reference)
- Appendix
3-17
3-3-1 Installation Site
Do not install the tag at any place below:
• Place where there is corrosive gas, flammable gas or iron powder.
• Place where the ambient temperature is out of the range between -10 and +70°C, where the temperature fluctuates considerably and
where moisture condensation occurs.
• In a microwave oven.
3-3-2 How to Install
Install the tag according to the following instructions:
• Neither shave, drill nor machine the tag.
• Do not apply any excessive force to the tag.
• Neither contact the tag and any metal with each other nor install the tag near any metal.
* When the tag is used in both high temperature and low temperature, the tag may bend. However, the function is not affected.
♦
Type V670-D13F03
•
Tag installation direction
Install this tag so that the tag surface can be in parallel with the antenna.
• Example of installation
Install the tag with the screws.
Antenna
M3 screw (Tightening torque: 0.6 N•m or less)
(Unit: mm)
3-3 Tag