User Manual
Table Of Contents
- V670 Series
- Introduction
- Contents
- Structure of This Manual
- Chapter 1 Features and System Configuration
- Chapter 2 Specifications and Performance
- Chapter 3 Setting and Installation
- Chapter 4 Functions
- Chapter 5 Control From Host Device
- Chapter 6 How to Use Self-Execution Mode
- Chapter 7 How to Use Programming Console
- Chapter 8 From Startup to Run
- Chapter 9 Characteristic Data Depending on Operating Condition (Reference)
- Appendix
3-16
3-2-1 Installation Site
♦
Installation site
Do not install the antenna at any place below:
• Place where the ambient temperature is out of the range between -10 and +70°C, where the temperature fluctuates considerably and
where moisture condensation occurs.
• Place where the relative humidity is out of the range between 35 and 85%RH.
• Place where there is corrosive gas, flammable gas, dust, salt or iron powder.
• Place affected by vibration or impact.
• Place splashed with water, oil or chemicals
3-2-2 How to Install
• Installation on a surface
•
Installation on the back
Insert a nut which comes with the antenna into the section A.
Note
When you install the antenna, be sure to follow the instructions above and test it fully.
M4 screw
(Tightening torque: 1.2 N•m or less)
(Unit: mm)
M4 nut
M4 screw
(Tightening torque: 1.2 N•m or less)
(Unit: mm)
3-2 Antenna