User Manual
Table Of Contents
- V670 Series
- Introduction
- Contents
- Structure of This Manual
- Chapter 1 Features and System Configuration
- Chapter 2 Specifications and Performance
- Chapter 3 Setting and Installation
- Chapter 4 Functions
- Chapter 5 Control From Host Device
- Chapter 6 How to Use Self-Execution Mode
- Chapter 7 How to Use Programming Console
- Chapter 8 From Startup to Run
- Chapter 9 Characteristic Data Depending on Operating Condition (Reference)
- Appendix
3-1 Controller
3-7
3-1-3 How to Install
The controller can be installed in a panel with screws or on a DIN rail.
♦
Installation in a panel
If you install the controller in a panel, be sure to use spring washers, flat washers and M4 screws. (Tightening torque: 1.2 N•m or less)
Do not use any organic solvent such as lock paint to fix screws. Otherwise, the case may crack.
♦
Installation on a DIN rail
(Unit: mm)
• When you install the controller on the DIN rail, hook the
controller over the A and push the controller in the direc-
tion B.
• When you remove the controller from the DIN rail, pull
the hook downward and remove the controller pushing
slightly upward.
Recommendable DIN rail
Model PFP-100N2 (Rail
length 1 m)
(OMRON)
DIN Rail
End Plate
Hook
Support Rail
Model PFP-100N2
End Plate
Model PFP-M
(Unit: mm)