User Manual
Table Of Contents
- V670 Series
- Introduction
- Contents
- Structure of This Manual
- Chapter 1 Features and System Configuration
- Chapter 2 Specifications and Performance
- Chapter 3 Setting and Installation
- Chapter 4 Functions
- Chapter 5 Control From Host Device
- Chapter 6 How to Use Self-Execution Mode
- Chapter 7 How to Use Programming Console
- Chapter 8 From Startup to Run
- Chapter 9 Characteristic Data Depending on Operating Condition (Reference)
- Appendix
3-1
3-1-1 Switch Setting
To set the switches, open a cover at the left upper part of the unit.
3-1-1-1 How to Open Cover
To open the cover, insert a screwdriver, which comes with the controller, into a notch at the left end of the cover.
When the cover opens, you can see the two node number setup switches (SW1 and SW2), two dip switches (SW3 and SW4) and con-
necting port for programming console.
Node number setup switch
Dip switch
Connecting port for programming
console
Chapter 3 Setting and Installation
3-1 Controller