User Manual

74
Section 4 SETTING OF INSPECTION CONDITION
ZFV-C
User’s Manual
Section 4
Inspecting by Width (WIDTH)
■ Items related to edge detection
Set the direction in which edges are searched and the density level.
● Selecting the color of edges
Select the direction of density change for the edge to be detected.
X MENU mode-[TEACH]-[CUSTM]-[EDGE MODE]
● Selecting the edge detection direction
Select the direction in which edges are searched.
X MENU mode-[TEACH]-[CUSTM]-[DIRECTION]
■ Items related to color
● Changing the color mode
ZFV-C has two color inspection modes as follows.
X MENU mode-[TEACH]-[CUSTM]-[COL MODE]
Setting Details
DARK Dark areas shown in the filtered monochrome image are assumed to be
edges.
LIGHT (default) Light areas shown in the filtered monochrome image are assumed to be
edges.
Setting Details
↑↓ Searches in the vertical direction.
← → (default) Searches in the horizontal direction.
Setting Details
FILTER (default) A color filter is used to increase the contrast with the background.
When [AUTO] filter is selected, a color filter that increases the contrast in the
area will be selected automatically.
It is also possible to select a filter that suits the workpiece.
PICKUP Select the color to be checked from a list of colors.
EDGE MODE: DARK
DIRECTION: ←→
Example)
Teaching area
To inspect this width