User Manual

Section 1 FEATURES
Section 1
Part Names and Functions
25
ZFV-C
User’s Manual
■ Sensor Head
(9) Sensor Head connector This connector connects the Sensor Head.
(10) Coupler This connector is used to connect two or more Amplifier Units. It is
located on both sides of the Amplifier Unit.
(11) I/O cable The I/O cable connects the Amplifier Unit to the power supply and exter-
nal devices, such as timing sensors or programmable controllers.
(12) USB port To connect a personal computer, connect a USB cable to this connector.
Before connecting/disconnecting the USB cable, make sure that no mea-
surement is in progress.
(13) RS-232C connector To connect a programmable controller or personal computer, connect a
RS-232C cable to this connector. The following dedicated RS-232C cable
shown below must be used. Use of a RS-232C other than the one given
below may result in malfunction or damage.
[For connecting a programmable controller]
ZS-XPT2
[For connecting a PC]
ZS-XRS2
No. Name Description
(2) Receiver part
(3) Connector
(4) Sensor Head
mounting fixture
(5) Focus adjustment
control
(1) Lighting part
(6) Ventilation
film
(7) Optional lighting
connector
(5) Focus
adjustment
control
(6) Ventilation film
(4) Sensor Head
mounting fixture
(3) Connector
(2) Receiver part
(1) Lighting part
(7) Optional lighting
connector
(3) Connector
(5) Focus adjustment
control
(6) Ventilation film
(4) Sensor Head
mounting fixture
(2) Receiver part
(1) Lighting part
ZFV-SC10
ZFV-SC50/SC50W
ZFV-SC90/SC90W