Datasheet

ZFV
C-11ZFV
Timing Charts
The following shows the timing charts when communication is performed with external devices.
Measurement
Continuos measurement
Measurement is performed continuosly for the duration that the TRIG signal is ON.
The measurement result is updated and output to external deveices at each measurement cycle.
Synchronuos measurement
Measurement is performed only once in synchrnous with the change in TRIG signal state from OFF to ON and the result is output.
• The minimum ON time width of the TRIG signal is 1 ms.
• The OUTPUT signal is helad until the measurement result is updated.
Note:However, when one-shot is set, the OUTPUT signal is held for the preset time.
To u t
TRIG
OUTPUT
ENABLE
OFF
ON
OFF
ON
OFF
ON
Tout: Measurement cycle
The measurement cycle changes
depending on the setting.
To u t
TRIG
OUTPUT
ENABLE
OFF
ON
OFF
ON
OFF
ON
Tout: Measurement time.
The measurement time changes
depending on the setting.