User Manual

Section 5 SETTING ADDITIONAL FUNCTIONS
Section 5
Setting the System Environment
99
ZFV-C
User’s Manual
I/O Monitor Function
This is a function to check the status of I/O signals.
X MENU mode-[SYS2]-[I/O MON]
Put the cursor on OUTPUT, ENABLE and ERROR, then press the SET button key to switch between “0”
and “1”. The external device operations can be checked by switching output OFF/ON when the actual
measurements are not being performed.
Setting Details
TRIG Displays ON/OFF status of TRIG signal. (0: OFF, 1: ON)
TEACH Displays ON/OFF status of TEACH signal. (0: OFF, 1: ON)
BANK Displays ON/OFF status of BANK signal. (0: OFF, 1: ON)
Expresses BANK1, BANK2, BANK3 sequentially from the right.
OUTPUT Displays ON/OFF status of OUTPUT signal. (0: OFF, 1: ON)
ENABLE Displays ON/OFF status of ENABLE signal. (0: OFF, 1: ON)
ERROR Displays ON/OFF status of ERROR signal. (0: OFF, 1: ON)
SYS2/I/O MON
TRIG
TEACH
BANK
OUTPUT
ENABLE
ERROR
:
:
:
:
:
:
0
0
000
0
0
1
OK
Signal status
(0: OFF, 1: ON)
Signal name