User Manual

Section 5 SETTING ADDITIONAL FUNCTIONS

Section 5

Setting the System Environment

ZFV-C

User’s Manual

Selecting the Measurement Timing

Set the timing that measurement is executed.

X MENU mode-[SYS1]-[MEAS TYPE]

Selecting the Teaching Mode from an External Device

There are two teaching modes from an external device.

X MENU mode-[SYS1]-[TEACH TYPE]

Timing Charts p.42

Setting Screen Display

The color of characters displayed on the LCD monitor and monitor’s background color can

be changed. Change the color when it is difficult to see the character or figure on the

image.

• Areas whose color can be changed

X MENU mode -[SYS1]-[DISP COL]

Setting Details

TRIG (default) Synchronous measurement

Measurement is performed in synchronous with the change in state of the exter-

nal TRIG signal from OFF to ON.

CONTINUE Continuous measurement

Measurement is repeatedly performed for the duration that the TRIG signal is ON.

Setting Details

STATIONARY (default) Teaching is performed with the workpiece in a stationary state. Input of the

external trigger is required for teaching.

MOVING The teaching is performed with the moving workpiece.

Select this teaching mode only when the workpiece cannot be stopped.

Input of the external trigger is required for teaching.

Setting

OK GREEN (default), RED, YELLOW, BLUE, WHITE

NG GREEN, RED (default), YELLOW, BLUE, WHITE

NORMAL GREEN, RED, YELLOW, BLUE, WHITE (default)

BACK GREEN, RED, YELLOW, BLUE (default), WHITE, BLACK

SYS1/DISP COL

1.OK

2.NG

3.DISP NRML

4.DISP BACK

OK/NG

NORMAL

BACK

NORMAL (color of characters)