Datasheet

XW5T
2
Part Names and Configuration
DIN Track Terminal Block (Top Surface) Basic Configuration
* Two-tier Terminal Blocks with a width of 3.5 mm are excluded.
Terminal (insertion) hole
Release hole (to release wire)
Label attachment section
Short Bar insertion holes
• You can attach a Short Bar to
either of the two holes.
• Insert the tester pins here to
perform a continuity check.
Note: 1. Do not insert more than one wire into
one terminal (insertion) hole.
2. Do not insert more than one Short
Bar into one Short Bar insertion hole.
Name Description
DIN Track
Terminal Blocks
Both Feed Through and Grounding Terminal Blocks are
available.
End Cover
This part is required to prevent electric shock.
Attach one End Cover to the exposed metal surface of the
last Terminal Block or to any Terminal Block that is next to
a different shape of Terminal Block.
End Brackets
End Brackets must be attached to both ends to hold the
Terminal Block in place.
Nameplate or
Labels
This part is available as an accessory.
Select the most suitable one for your needs.
You can also use commercially available nameplates that
are 9.5 mm wide and 0.5 mm thick. *
Short Bar
This part is available as an accessory.
Select one as required.
DIN Track
Terminal Block
End Cover
End Brackets
Nameplate or Labels
Short Bar
End Brackets