Datasheet

XS2

(5) Mounting Cap

• After mounting the cover to the pin block and the cover

snaps into place, tighten the cap securely by hand (0.39 to

0.49 N·m)

Note: If the cap is not tighten securely enough, the degree of protection (IP67)

may not be maintained or vibration may cause the cap to become loose.

Do not tighten the cap with pliers or similar tools; they may damage the

cap.

• After fully tightening the cap, length A should be

approximately one of the following according to the cable

external diameter and the Connector model. (Use these as

a guide.)

(6) After Assembly

• Confirm the insulation between cores after completing

assembly.

Recommended Cables

When connecting a commercially available cable to a

connector assembly, use a cable with an outside diameter of

3 to 6 mm and core conductor sizes of 0.18 to 0.75 mm

for

crimping connectors and 0.5 mm

maximum for soldering

connectors.

Connector Arrangement

For safety, when constructing a connection system between a

Sensor and panel with a connector, make sure that the

connector plug is on the Sensor side and the connector socket

is on the panel side (i.e., the female pins are located on the

power-supply side).

External diameter of

applicable cable

Cable external diameter (mm)

6 mm 5 mm 4 mm 3 mm

For 6-mm-dia. cable 10——

For 4-mm-dia. cable —2 1—

For 3-mm-dia. cable —— 2 1

Cap

Sensor Side

Connecting Cable

Panel Side

(Power-supply Side)

(Plug)

(Socket)

(Plug) (Socket)