Datasheet

XS2
22
• Loosen the screws on pins 1 to 4 and insert the cores
according to the pin numbers.
• Use the dedicated Screwdriver (XW4Z-00B)* and tighten
the screws securely so that the cores do not pull out. (0.15
to 0.2 N·m)
• Five-pole Connectors
• Strip the cable sheath for a total of 15 mm and strip the core
covering for 8 mm for the core to connect to pin 5.
• Connect the core to pin 5 (in the center) first.
• Insert the core from the side of the hold with the tab and
tighten the screw securely (tightening torque: Pins 1 to 4:
0.15 to 0.2 N·m, Pin 5: 0.03 to 0.05 N·m), and then cut off
the excess wire with wire cutters.
• Bend the cable as shown below, attached the enclosed
insulation cap, and then strip the other cores.
• Connect the cores to pins 1 to 4.
Connecting Shielded Cables to Five-pole Connectors
• Place the insulation tub on the drain line of the shield and
connect it to the terminal.
• Tighten the screw and then check visually to see if there is
insulation between the cores.
*When tightening the screws, use the dedicated XW4Z-00B Screwdriver
that matches with the screw-slot dimensions.
(4) Inserting Pin Block
• Mount the cover to the pin block so that the triangle mark on
the pin block will coincide with the triangle mark on the
cover.
• If the cover is used for a Right-angle model, the relationship
between the position of the polarity key on the engaged side
and cable connection direction will be determined by the
direction in which the positioning key is inserted into the
cover, which can be rotated by 90°.
• Fully insert the positioning key until the positioning key is
hidden by the casing.
• Align the triangular marks on the pin block and cover and
insert the pin block into the cover.
• Press them together firmly until the pin block does not come
out of the cover. (0.39 to 0.49 N·m)
Screw-on Connectors
8
12
12
±0.5
Dressing the Cable End
• Four-pole Connectors
87
8
12
Conductors for
pins 1 to 4
Conductors for
pin 5
Screw
Special
Screwdriver
Special
Screwdriver
Screw
Ta b
Insulation cap
Insulation tube
Drain line
Screwdriver
XW4Z-00B
Lock spring
O-ring
Triangle mark
Positioning key
(triangle mark)
Polarity key
Pin block
(Soldering Model)
Cover
(Straight Model)
(Crimping Model)
(Right-angle Model)
Triangle mark
Pin block
Cover lock
Cover
Pin block
(Screw-on Connectors)