Datasheet

WL-N/WLM-N
9
Model Number Legend (Not all combinations are possible. Contact your OMRON representative for details.)
(1) Actuator and Property Specifications (2) Built-in Switch Type
(3) Indicator Type
(4) Connector Type
*1. DC models are certified for EN/IEC (CE Marking).
*2. Refer to Contact Forms on page 16 for details on connector pin numbers.
*3. The standard cable length is 0.3 m. Contact your OMRON representative for information on other cable lengths.
General-purpose Switches
Sensor I/O Connector Switches
WL@ - @ LD@ -N
(1) (2) (3) (4)
Code Lever Pretravel (PT)
CA2 Roller lever: R38 mm 15±5°
G2 Roller lever, high sensitivity: R38 mm 10°
GCA2 Roller lever, high precision: R38 mm 5°
D28 Sealed top-roller plunger 1.7 mm
+2°
−1°
+2°
0°
Code Specification
Blank Standard built-in switch
55 Airtight built-in switch
Code Specifications
LD LED (10 to 115 VAC/DC)
Code
Specification
Shape Voltage used *1 Wiring locations Connector pin No. *2
K13A
Direct-wired connector Threaded (M12)
AC NO only NO:
K13 DC NO only NO:
K43A AC NC+NO NC: , NO:
K43 DC NC+NO NC: , NO:
-M1J
Pre-wired connector *3
Threaded (M12)
DC NO only NO:
-M1GJ DC NO only NO:
-M1JB DC NC only NC:
-AGJ AC NC+NO NC: , NO:
-DGJ DC NC+NO NC: , NO:
-DK1EJ DC NO only NC: , NO:
-M1TJ
Smartclick
DC NO only NO:
-M1TGJ DC NO only NO:
-M1TJB DC NC only NC:
-DTGJ DC NC+NO NC: , NO:
-DTK1EJ DC NO only NC: , NO:
3 4
3 4
1 2
3 4
1 2
3 4
3 4
1 4
2 3
1 2
3 4
1 2
3 4
2
3 4
3 4
1 4
2 3
1 2
3 4
2
3 4