Datasheet

ManualsBrandsOmron Industrial Automation ManualsMiscellaneous Sensor AccessoriesElectrode Holder Suitable for Level Switches

PS-@S(R)/-31

■ PS-@S(R) Electrode Holder Accessories (Order Separately)

■ PS-31 Electrode Holder Accessories (Order Separately)

■ Accessories Required for Connecting the PS-@S(R) and Electrodes

(Order Separately)

Electrodes Shorter

Than 1 m

The following items are required

for each pole.

• 1 × F03-01 Electrode

• 1 × F03-03 Lock Nut

The Electrode can be cut

anywhere based on the control

level.

Electrode Longer

Than 1 m

The following items are required for every

additional meter of electrode for each pole.

• 1 × F03-01 Electrode

• 1 × F03-02 Connecting Nut

• 2 × F03-03 Lock Nuts

Use F03-14 1P, 3P, and 5P Separators to

prevent the electrodes from touching each

another.

Note: 1. The spring washer comes with the lock nut.

2. Refer to F03-

for details on Electrodes, Connecting Nuts, Lock Nuts, and Separators.

F03-11 Protective Cover F03-12 Spring Clamp F03-13 Mounting Frame for installing in

concrete

F03-31 Dust-proof Rubber Bushing

120 dia.

Electrode

Weight:

approx. 65g

Operating

temp.: −10°C

to 70°C

Use this Cover for PS-series Electrode

Holders with Mounting Frames (upper

one in the following illustration), This

Cover can also be used when installing

the BF-series Electrode Holders

outdoors. Since this Cover is not

water-proof, water or dust may enter

through the wire hole (lower one below).

Applicable Electrode Holders:

BF-3, BF-4, BF-5, PS-3S(R), PS-4S(R),

PS-5S(R)

Electrode

Four, M5 x 25

mounting

screws

112 dia.

Used to clamp an Electrode Holder

with ease, as shown in the illustrations,

when the Electrode Holder is applied

to a tank without a coupling.

Squeeze the mounting frame into

the Holder as shown below.

Applicable Electrode Holders:

PS-3S(R), PS-4S(R), PS-5S

Useful frame for burying in concrete. Cut

as required based on the concrete depth.

115 dia.

72 dia.

82 dia.

100

Commonly used with

Mounting Frame

Electrode

Mounting Frame

embedded into

concrete

6 dia. (inner)

32 dia.

Note: This Bushing is not waterproof.

Material: Silicon rubber

Spring washer (See note 1.)

Lock nut

Electrode

Separator (1-pole)

Lock nut

Electrode

Spring washer

Connecting nut

http://www.ia.omron.com/