Datasheet

NS Series
3
Configuration of CS series, CJ series and CP series
1:1 NT Link or Host Link
The PT can be connected to an OMRON Controller Link network by mounting a Controller Link Interface Unit.
If an Ethernet-compatible NS-series PT is used, the PT can connect to a PLC with an Ethernet Unit and an Option Unit is not needed to connect at the PT.
The NS-series PTs can connect to a variety of devices in the network, through as many as 3 network levels.
For example, if SAP (Smart Active Parts) are being used, an NS-series PT connected by Ethernet can be used to monitor the information in a PLC
connected through Controller Link as well as the information in the DeviceNet Slaves connected to that PLC.
2 Serial connection
3 Controller Link Connection
4 EtherNet/IP or Ethernet Connection
5 Connections Over Network Levels
PLC
NS-series PT
NS-series
PT
NS-series
PT
NS-series
PT
NS-series PT
PLCPLC
NS-AL002 Converter
(Converts between
RS-232C and RS-422A.)
PLC
NS:PLC = 1:1 NS:PLC = 1:2
NS:PLC ratio = 8:1 max.
Connecting with the PLC through port A or port B
Up to 8 NS-series PTs can be connected to each of the PLC's RS-232C/RS-422A ports.
1:N NT Link
NS-CLK21
If a Controller Link connection
is used, data links can be set
between PLCs and multiple
PLCs can be monitored/set
from the NS-series PT's screen.
2 Mbps (500 m max.)
1 Mbps (800 m max.)
500 kbps (1 km max.)
NS Series
PT
PLC PLC PLC
Baud rate
Max. number of nodes: 32 nodes
NS Series PT
NS Series PT
PLC PLC PLC
Personal computer
DeviceNet
NS Series
PT
Seamless and
Program-less
Seamless and
Program-less
NS Series
PT
Ethernet
Controller Link
PLC
PLC PLC