Datasheet

31
Design Startup/Operation Maintenance NS-Runtime Features Network System Configuration Ordering Information Specifications
Hand-held PT
Yes, the
problem
is here!
4. Forced ON
Check and Change I/O While You View the Ladder Diagram on the I/O Monitor
Display and change the present value by specifying the address. It is also possible
to force-set/reset bits with the I/O monitor.
Force-setting and force-resetting are possible
Locations that have been force-set are displayed in pink and can be checked at a
glance.
1.Select the input bit for which the output will be forced ON.
“Find Back”, “Find Next”, useful Function Supported by the NS-series.
Reduced Time to Investigate Which Output or Input Is Causing the Problem.
Return to the previous search position.
Find the output from the input bit or find the
input bit from the output at the cursor.
Find the address at specified by the cursor.
“B” Key
“Space” Key
“N” Key
Double-click
Function
Operation with NS-series PT. CX-Programmer
Next
Back
Back
Change
ubl
e-c
li
n
with
NS
-
series
PT.
N
e
xt
B
ac
k
i
ck
k
2.
Is this input the cause?
What output corresponds
to this input?
1.
Why is this output
not turning ON?
3.
Why is this
output not turning ON?
5.
There’s no problem
with input CIO 21.00.
Let’s go back to the
previous program section.
4.
Which of these two
inputs is the cause? Let’s
look at CIO 21.00 first.
6.
So is it input CIO
21.01 after all?
Select the address
by touching the panel.
Select the Forced Set Option and
then press the Update Button.
2.
3.
Minor changes in values of timers or counters can be made without Support Software.
Make the selection with
the I/O monitor by touching
the screen.
Changing the present value
of the address selected with
the Change Value Button
The Ladder Monitor function is not supported by the 5.7-inch models.
Note: