Datasheet

28
NS
CX-Designer
CX-Programmer
Note: Communications across network layers can be performed.
USB relay cable
(IP65 oil-proof type)
(sold separately:
NS-USBEXT-1M)
Commercially
available USB
cable
SPMA can be used in CS/CJ-series PLCs with lot number
030201 or later.
SPMA via a PLC is not supported when a CP-series PLC is
connected. (SPMA via an NS-series PT is supported with a
CP-series PLC.)
CX-Programmer version 8.2 and higher support automatic
online connection via the PT. NS system version 8.2 or higher is
required.
Note 1:
Note 2:
Note 3:
Single Port Multi Access (SPMA)
Transfer ladder program data to the PLC via
the PT. Perform online editing via the PT.
Transfer screen data via the PLC.
Comparison
The on-site NS screen can be compared with the computer screen.
NEW
PT Transfer Compare
Comparison
result
USB connection is
supported only for CJ2 PLCs.
Note:
The ladder program can be transferred.
The ladder program can be transferred.
A search is automatically made for the PLCs
connected to the PT and the results are displayed
using the automatic online connection function in the
CX-Programmer. Just select a PLC from the list to
connect. This function is also supported for PLCs over
network layers.
Use a USB relay cable to enable performing
maintenance from in front of the control panel.
Using a USB relay cable greatly improves
debugging at equipment startup.
Easy Automatic Connection
CX-Programmer
Automatic
search
PLCs registered to the PT are automatically searched for.
Make the connection simply by selecting from the PLC list.
PLC
Ladder program
Ladder program
USB or
Ethernet
Serial connection
(1: N NT Link only)
Ethernet
Controller Link
NSCX-Programmer
Ethernet or Controller Link
Computer (Serial)
PLC (Ethernet or Controller Link) NS-series PT
Computer (Serial/USB) NS-series PT (Ethernet)
PLC (Ethernet or Controller Link) PLC
The comparison function of the CX-Designer enables the following comparison.
CX-Designer project Project in the computer
CX-Designer project NS project
PLC NS
Ethernet or Controller Link
Serial
USB/Serial or
Ethernet (See note.)
CX-Designer
Screen data
Screen data
Screen data
Keep connected.
Keep connected.
Same in screen
Different in screen
Screen added
Screen deleted
Same
Different
Added
Deleted
Comparison