Datasheet

25
Design Startup/Operation Maintenance NS-Runtime Features Network System Configuration Ordering Information SpecificationsHand-held PT
The I/O comment is used as the label.
(2) Check the comment then drag-and-drop the symbol from the symbol table to the property list.
Drag
&
Drop
Drag
&
Drop
Drag
&
Drop
Reading the Symbol Table
The symbol table created in the CX-Programmer
during ladder programming can be read into the
CX-Designer by dragging and dropping, so it isn't
necessary to manually data such as input addresses
and I/O comments. Tags (i.e., network symbols) can
also be read into the CX-Designer.
The symbol table read from the CX-Programmer can
be directly dragged and dropped to the touch switch
and lamp.
If Use I/O comment is selected in advance for the Use
symbol text as label, the I/O comments are automati-
cally used as labels when addresses are dragged
and dropped from the symbol table. (If Use symbol
names is selected, the symbol names are used as the
labels.)
Version 8.0 or higher of the CX-Programmer support tags
(i.e., network symbols).
(1) Create a switch on the screen.
(3) Allocations for buttons and
lamps can also be checked on
the screen using comments
imported from the
CX-Programmer.
Example of Easy Address Allocation
Note:
CX-Programmer's
symbol table
CX-Designer's
symbol table
The CX-Programmer's
symbol table can be
dragged and dropped!
Example of Reading the Symbol Table
Example of Reading I/O Comments