Datasheet

“Find Back”, “Find Next”, useful function supported by the NS-series.
Reduced Time to Investigate Which Output or Input Is Causing the Problem.
Force-setting and force-resetting are possible
Locations that have been force-set are displayed in pink and can be checked at a glance.
Check and change I/O While You View the Ladder Diagram on the I/O Monitor
Display and change the present value by specifying the address. It is also possible to force-set/reset bits with the I/O monitor.
Yes, the
problem is
here!
Device Monitor function
Find the address at specified by the cursor.
Find the output from the input bit or find the
input bit from the output at the cursor.
Return to the previous search position.
.Is this input the cause?
What output corresponds
to this input?
. Select the input bit for which the output will be
forced ON.
. Select the address by
touching the panel.
Make the selection with the I/O
monitor by touching the screen.
Changing the present value of the
address selected with the Change
Value Button.
Minor changes in values of timers or counters can be made without support software.
. Forced ON
Back
.Select the Forced Set option
and then press the update
Button.
.Why is this output
not turning ON?
.Why is this output
not turning ON?
.There’s no problem
with input CIO ..
Let’s go back to the
previous program
section.
.Which of these two
inputs is the cause? Let’s
look at CIO . first.
.So is it input CIO .
after all?
“N” Key
“Space” Key
“B” Key
Next
Double-click
Back
Operation with NS-series HMI CX-Programmer
Note: The Ladder Monitor function is not
supported by the 5.7-inch models.
31
Order/version: 2447841/010 (width: 210mm, height: 297mm)
Print type: NS Brochure - Central Print, Full color, with extra spotcolor(s)
Produced by Adnovate on 03-apr-2012 at 10:46:40 in Adobe InDesign 7.0.4.553
Low resolution proof not suitable for production purposes
Page: 31