Datasheet

K8DT-TH
7
DIP Switch Functions
K8DT-TH1
Note: The default setting is 0°C.
Note: All pins are set to OFF by default.
K8DT-TH2
Note: The default setting is 0°C.
Note: All pins are set to OFF by default.
R_SW3 100°C/°F units (0 to 9)
R_SW2 10°C/°F units (0 to 9)
R_SW1 1°C/°F units (0 to 9)
PIN
ON ❍↑
OFF ●↓
Alarm Mode
Upper limit ● --- --- --- --- --- ---
Not used.
Lower limit ❍ --- --- --- --- --- ---
Latching
With latching --- ● --- --- --- --- ---
Without latching --- ❍ --- --- --- --- ---
Output drive
method
Normally open --- --- ● --- --- --- ---
Normally closed --- --- ❍ --- --- --- ---
Temperature
unit
°C --- --- --- ● --- --- ---
°F --- --- --- ❍ --- --- ---
Input type
K --- --- --- --- ●●●
J --- --- --- --- ●●❍
T --- --- --- --- ●❍●
E --- --- --- --- ●❍❍
Pt100 --- --- --- --- ❍●●
Pt1000 --- --- --- --- ❍●❍
NOT USE --- --- --- --- ❍❍●
NOT USE --- --- --- --- ❍❍❍
R_SW3
1,000°C/°F units (0 to 3)
Note: A temperature setting error occurs if this switch
is set to a value from 4 to 9.
R_SW2 100°C/°F units (0 to 9)
R_SW1 10°C/°F units (0 to 9)
PIN
ON ❍↑
OFF ●↓
Alarm Mode
Upper limit ● --- --- --- --- --- ---
Not used.
Lower limit ❍ --- --- --- --- --- ---
Latching
With latching --- ● --- --- --- --- ---
Without latching --- ❍ --- --- --- --- ---
Output drive
method
Normally open --- --- ● --- --- --- ---
Normally closed --- --- ❍ --- --- --- ---
Temperature
unit
°C --- --- --- ● --- --- ---
°F --- --- --- ❍ --- --- ---
Input type
K --- --- --- --- ●●●
J --- --- --- --- ●●❍
T --- --- --- --- ●❍●
E --- --- --- --- ●❍❍
B --- --- --- --- ❍●●
R --- --- --- --- ❍●❍
S --- --- --- --- ❍❍●
PL II --- --- --- --- ❍❍❍
1
ON
OFF
2
3
4
5 6 7
8
1
ON
OFF
2
3
4
5 6 7
8