Datasheet

K6CM
3
Dedicated tool
LAN
EtherNet/IP
Built-in EtherNet/IP port
Object monitored
K6CM-ISM
1 m (extendable to 100 m)
Single-phase
power supply
Output signal
(transistor output)
40 m max. (From ZCT to motor.
Extendable in some conditions) *1
Note: Even without a computer, the alarm bar of the main unit notifies you of changes of motor state.
By keeping a computer or PLC
continuously connected, you can
monitor the state of a motor.
S
T
R
N
7.5 kW or less
(Measurement error
increases when this
value is exceeded.)
When an inverter is used with three-phase,
four-conductor, N-phase ground, correct
measurement is not possible
Note:
(pre-wired cable)
1 m
(pre-wired cable)
Three-phase, four-conductor, N-phase ground
*1. For details, refer to the
technical data on page 16.
Comprehensive current diagnosis type (K6CM-CI)
Dedicated tool
LAN
EtherNet/IP
Object monitored
Single-phase
power supply
Measurement
trigger signal
K6CM-CIM
K6CM-CIC (CT)
Any type of
single-phase
measurement
Three-phase
power supply
Note: Even without a computer, the alarm bar of the main unit notifies you of changes of motor state.
By keeping a computer or PLC
continuously connected, you can
monitor the state of a motor.
0.75 kW to 300 kW (400 V)
0.75 kW to 150 kW (200 V)
Built-in EtherNet/IP port
2.9 m
Output signal
(transistor output)
Inverter *2
(Measurement is also
possible without an inverter)
(pre-wired cable)
*2. When an inverter is used, the
Degradation level may increase even with
a normal motor. Adjust the alarm
threshold to match the installation
environment.