Datasheet

HL-5000
HL-5000
5
Sealed Roller Plunger
HL-5200
Coil Spring
HL-5300
12.7 dia. × 4.8
stainless steel roller
Two, M3 head
clamping screws
Note: The head can be mounted in either of the two direc-
tions. Dimensions not shown are the same as
HL-5000.
Resin rod
Two, M3 head
clamping
screws
6.6 dia.
3.2 dia.
(See note)
PT
4.1
(19)
16.5
20.2
60.6
OP
50±0.2
PT
4.1
16.5
(19)
20.2
110±2.5
50±0.2
38±0.2
42±0.2
60.6
(See note 1)
Note: 1. The coil spring may be operated from any direc-
tions except axial directions (↓).
2. Be sure to use the dog or cam within 30 mm
from the top end of the spring. (Avoid use within
80 mm from the mounting hole.)
3. Dimensions not shown are the same as
HL-5000.
30 (see
note 2)
Three, M3 head
Operation of Limit Switch
Actuator Position Change (HL-5000, HL-5030,
HL-5050)
To change the angle of the actuator, loosen the Allen-head bolt on
the side of the actuator lever. Then the actuator can be set at any
angle.
Loosen the Allen-
head bold
Head Direction Change (HL-5000, HL-5030)
(HL-5050, HL5200)
To change the head direction, loosen the two mounting screws.
Then the head can be changed at 90° increments in one of four
directions.
HL-5000
HL-5030
HL-5050
Head mounting screw
(Small white screw that
can be turned with either
a Phillips-head or
flat-blade screwdriver)
Head mounting screw
(Black non-removable
torque screw)
Head mounting screw
(Small white screw that
can be turned with either
a Phillips head or
flat-blade screwdriver)
Head mounting screw
(Black non-removable
torque screw)